OSSP logo  Open-Source Psychometrics Project
( home · about )

Shows real-time angle measurements down to decimal fractions of a degree.

BEND THE PAST.

For any official documentation, always start with an Amada subsidiary. Use the table below to find contact options for key regions. Always be ready to provide your machine's full model number and serial number for accurate support.

Line-of-sight obstruction, dirty IR lens, or low battery power.

The rhythmic hum of the fabrication shop was the only music Elias needed, but today, the harmony was off. He stood before the Amada press brake

Clean the master block and the DigiPro blades thoroughly with isopropyl alcohol. Clamp the DigiPro blades firmly into the master block.

A wireless (infrared or radio frequency) or cable connection that sends the measured angle directly to the press brake controller.

If you need help with a specific model of the , please tell me:

Always store the DigiPro in its original padded protective case when not in use. Never leave it resting on the press brake bed where vibrations or falling parts can damage it.

The Amada DigiPro is an electronic angle-measuring device used heavily in sheet metal fabrication. It transmits precise bending angles directly to the Amada press brake CNC control. This eliminates manual measurement errors and speeds up setup times.

Amada Digipro Manual ~repack~ (2025)

Shows real-time angle measurements down to decimal fractions of a degree.

BEND THE PAST.

For any official documentation, always start with an Amada subsidiary. Use the table below to find contact options for key regions. Always be ready to provide your machine's full model number and serial number for accurate support. amada digipro manual

Line-of-sight obstruction, dirty IR lens, or low battery power.

The rhythmic hum of the fabrication shop was the only music Elias needed, but today, the harmony was off. He stood before the Amada press brake Shows real-time angle measurements down to decimal fractions

Clean the master block and the DigiPro blades thoroughly with isopropyl alcohol. Clamp the DigiPro blades firmly into the master block.

A wireless (infrared or radio frequency) or cable connection that sends the measured angle directly to the press brake controller. Use the table below to find contact options for key regions

If you need help with a specific model of the , please tell me:

Always store the DigiPro in its original padded protective case when not in use. Never leave it resting on the press brake bed where vibrations or falling parts can damage it.

The Amada DigiPro is an electronic angle-measuring device used heavily in sheet metal fabrication. It transmits precise bending angles directly to the Amada press brake CNC control. This eliminates manual measurement errors and speeds up setup times.