Periodically check the plastic coating on the cables. If you see peeling, fraying, or exposed wire, replace the cable immediately.
The padded components are attached last to give you maximum access to the frame.
Wipe down the chrome guide rods with a silicone-based spray lubricant once every three months. Never use WD-40, as it attracts dust.
Bolt the horizontal seat support frame to the central upright post. dp dual trac 20 assembly instructions full
: Common hardware includes 3” cap screws with hinged covers and 2” coated deck screws for any wooden or reinforced attachments. Resources for Manuals
For selectorized units:
Attach the cable ends to the weight stack and the designated handles (leg lift, curl bar, lat bar). Step 6: Final Tightening and Safety Check Periodically check the plastic coating on the cables
Before you begin, ensure you have sufficient space. The machine should be assembled in the location where it will be used.
Bolts, washers, nylon locking nuts, and cotter pins.
Due to the weight and size of the main frame components, this assembly is a two-person job. Clear Workspace: Ensure you have at least a space for assembly. Wipe down the chrome guide rods with a
Drop the cable straight down. Drop it through a floating pulley block (a double-pulley bracket that hangs in mid-air between the top frame and the weights).
After routing and attaching handles, you must set correct cable tension.